TMR Customs Forged Lifetime Heims - How to Rebuild!

TMR Customs Forged Lifetime Heims - How to Rebuild!

How to Rebuild TMR Customs Forged Lifetime Heims with Bronze Races

Keeping your heims in top shape is easy with TMR Customs' Forged Lifetime Heims featuring Bronze Races. Follow this step-by-step guide for a proper rebuild.

Tools & Materials Needed:

  • TMR’s Lifetime Heim Assembly/Spanner Tool

  • Propane or suitable torch (optional for loosening Loctite)

  • Blue Loctite 243

  • High-moly grease (Amsoil Synthetic Polymeric Off-Road Grease NLGI #2, RCV Performance Synthetic Moly Grease, or equivalent)

  • Clean rags or shop towels

Disassembly Tips

  1. Clean the Joint: Before starting, thoroughly clean the joint to remove dirt and debris.

  2. Prepare for Removal: The red spanner nut, set screw, and grease zerk are secured with Blue Loctite. To break the Loctite’s bond, consider applying light heat with a propane torch.

  3. Use the Right Tool: The TMR Lifetime Heim Assembly/Spanner Tool is essential for safely removing the red spanner nut.

Assembly Steps

  1. Grease the Housing: Apply a light coat of grease inside the heim housing.

  2. Install O-Rings: Insert one O-ring into each bronze race.

  3. Grease Wear Surfaces: Lightly grease both bronze races and the ball.

  4. Insert the First Bronze Race: Place the first bronze race into the heim housing.

  5. Position the Ball: Insert the ball into the housing.

  6. Install the Second Bronze Race: Fit the second bronze race into position.

  7. Secure the Spanner Nut: Apply Blue Loctite 243 to the red spanner nut and torque it to 35 ft/lbs (7/8" Lifetime Heims), 40 ft/lbs (1-1/4" Lifetime Heims). 

  8. Adjust for Locking Groove Alignment: Back off the red spanner nut until the nearest alignment groove matches up with the set screw hole.

  9. Install the Set Screw: Apply Blue Loctite 243 to the set screw and install it. The set screw needs to be lightly tightened by hand. Do not over tighten it. 

  10. Install the Grease Zerk: Secure the grease zerk with Blue Loctite 243.

    By following these steps, you’ll extend the life of your heims and maintain peak performance. If you need any additional parts or tools, visit TMR Customs!

Back to Blog